3500/33-01-00框架仪表系统振动

产品标题:Модуль 3500/33-01-00 Bently框架仪表系统振动监测继电器模块

型号： 3500/33-01-00

品牌：本特利

　产品介绍

　　型号名称：3500-33-01-00伺服控制器

　　3500-33-01-00 注意出现下面四种情况时的读数

　　（1） 按下量程Ⅰ按纽是，如果显示器全不发光，说明读数低于7%，如果显示器只有*下面一只发光管发光，说明读数高于或等于15%，应改按量程Ⅱ按纽，再读数。

　　（2） 按下量程Ⅱ按纽时，如果显示器全不发光，说明读数低于16%，应改按量程Ⅰ按纽再读数，如果显示器只有*下面一只发光管发光：说明读数高于或等于35%。

　　（3） 按下量程Ⅰ按纽或量程Ⅱ按纽时，如果显示器相 二只发光管都发光，则读数可取这二位读数的平均值，还可以根据不同的亮度，按比例增减读数。

　　（4） 换电池：如果以上检查测量还不到要求或显示器发光暗淡，或电池电压低于10V时，应更换新电池的使用。`

　　四、 维修保养

　　1、 本仪表为高阻仪器，各部分要有良好的绝缘性，使用保存时要注意防潮防湿，保持干燥清，以免影响测量准确性。

　　2、 发光管发光工作电流5mA左右，干电池只能间断放电，所以平时不要长时间按下量程按纽，只有当检查或测量读数时才短时间按。动一下即可，以节约用电。

　　3、 仪表保存的地方应清 ，其环境温度为0-40℃，相对温度小于85%，长期不使用，要把电池从盒内取出。

　　本店所销售产品均为原包装全新产品,大量供应.

　　类型：针式

　　测量范围：水分：0～50%

　　温度：-10～60℃

　　准确度： ±(0.5%n+1)

　　分辨率：0.1

　　电源：4节5号电池

　　外形尺寸：182X68X38mm

　　测杆尺寸：170x44x25mm

　　重量：334g（不含电池）

　　应用：木材、木质纤维类物质如竹制品、木器、中药材、烟草、棉花、纸张等非导电类物质的含水率测定。

　　Product introduction

　　Model name: 3500-33-01-00

　　3500-33-01-00 Note the readings when the following four conditions occur

　　(1) Press the range I button. If the display does not emit light, it indicates that the reading is lower than 7%. If the display has only the lowest light-emitting tube emitting light, it indicates that the reading is higher than or equal to 15%. Press the range II button and read again.

　　(2) When pressing the range II button, if the display does not emit light at all, it indicates that the reading is lower than 16%, it should be read again by pressing the range I button. If the display has only the lowest luminous tube emitting light: it indicates that the reading is higher than or equal to 35%.

　　(3) When the range I button or range II button is pressed, if the two light-emitting tubes of the display are illuminated, the reading can take the average value of the two readings, and the reading can be increased or decreased in proportion according to different brightness.

　　(4) Replace the battery: if the above inspection and measurement are not up to the requirements, or the display is dim, or the battery voltage is lower than 10V, replace the battery`

　　4、 Maintenance

　　1. This instrument is a high resistance instrument. All parts should have good insulation. Pay attention to moisture-proof and moisture-proof during use and storage, and keep it dry and clean, so as not to affect the measurement accuracy.

　　2. The luminous current of the luminous tube is about 5mA, and the dry battery can only discharge intermittently. Therefore, do not press the range button for a long time at ordinary times, and only press it for a short time when checking or measuring the reading. Just move it to save electricity.

　　3. The storage place of the instrument shall be clean. The ambient temperature is 0-40 ℃, and the relative temperature is less than 85%. If it is not used for a long time, take out the battery from the box.

　　The products sold in our shop are all new products in original packaging and are available in large quantities from stock

　　Type: needle type

　　Measurement range: moisture: 0 ~ 50%

　　Temperature: - 10 ~ 60 ℃

　　Accuracy: ± (0.5% N + 1)

　　Resolution: 0.1

　　Power supply: 4 No. 5 batteries

　　Overall dimension: 182x68x38mm

　　Measuring rod size: 170x44x25mm

　　Weight: 334g (excluding battery)

　　Application: Determination of moisture content of wood, wood fiber substances such as bamboo products, woodwork, traditional Chinese medicine, tobacco, cotton, paper and other non-conductive substances.

免责声明：

AMIKON我们销售新产品和停产产品，独立渠道购买此类特色产品。阿米控不是本网站特色产品的授权分销商、经销商或代表。本网站上使用的所有产品名称/产品图片、商标、品牌和徽标均为其各自所有者的财产。带有这些名称,图片、商标、品牌和徽标的产品描述、描写或销售仅用于识别目的，并不表示与任何权利持有人有任何关联或授权